Hello all,
We’re currently trying to use uManager 2.0 to drive a Nikon TiE, CoolLed PE 300 and a Prime BSI camera for a multi-position time lapse experiment. The set up has been relatively straight forward but we are running into an issue where the first two images of the time-lapse are taken while the stage is in transit to the position similar to
We have tried the solution that Nico had previously suggested of adjusting the core time out to longer than the transit but this has made no impact.
I was wondering if there was a way that we could potentially circumvent this issue by adding a delay to the first frame of the acquisition to compensate for the lack of synchronization between stage and camera.
Any insight or help would be gratefully received.
Best wishes,
Rob